View Single Post
  #18  
Old 08-05-2019, 10:47 PM
kopek is offline
born to be shunned
 
Join Date: Jul 2007
Location: Southwestern PA
Posts: 15,201
I had the same set and another equally cheap-but-serviceable set for metrics. Almost everything I did was SAE; almost. But it wasn't until the mid-80s to late 80s that I finally broke down and got Craftsman metrics (with a few Snap-on for some specialized stuff).

Now my prized possession is two very old Craftsman sets - 1/4 and 3/8 drive - with 8-point sockets for the old 4-point/square nuts used in furniture. From back when they made some really good cabinet tools. Those, like my double-deep sockets for doing the tension adjustments on car trunks, stay in the safe and not in the toolbox.