View Single Post
  #17  
Old 06-27-2019, 05:39 AM
Snnipe 70E is offline
Guest
 
Join Date: Oct 2008
Location: San Jose, CA
Posts: 4,040
Quote:
Originally Posted by PoppaSan View Post
It is serious. Mostly it is found by empirical evidence. Turn off light in kitchen and living room lights dim. Motors seem to surge or not run at rated speed; sometimes faster sometimes slower. Motion activated LEDs stay on dim with the switch off. I've smoked electronics by knocking a wire nut off in a junction box. One reason not to share neutrals between circuits.
For your house, a loss at the transformer requires a call to your power utility. Your breaker panel mains would require a pro.
If you suspect one and your house is fairly recent, on a turned off line I'd check for continuity between the neutral and ground at an outlet. That would be the slot that shows zero voltage to ground normally. With everything else on the circuit unplugged, run a space heater and, on an unused outlet but same circuit, check for voltage between neutral and ground. That should still be zero. This checks that specific circuit between that point and the breaker panel mains.

Or get this for <$20.

Also check voltage between the hot and neutral at any outlet. It should reed between 110 and 130 VAC.

When I built my kitchen out I was required to have two 20 amp circuits, one feeding one side of the kitchen and the other the other side. With GFI protection on any outlets within 3 feet of water. A decated 20 amp circuit for the Frig and dishwasher and I believe one for the desposal.
__________________
Old Snipes do not die they just loose their steam

Last edited by Snnipe 70E; 06-27-2019 at 05:44 AM.