# plumbers/pipefitters- identifying thread size

**URL:** <https://boards.straightdope.com/t/plumbers-pipefitters-identifying-thread-size/805799>\
**Category:** Factual Questions\
**Created:** [January 3, 2018, 3:07pm UTC](https://boards.straightdope.com/t/plumbers-pipefitters-identifying-thread-size/805799 "2018-01-03T15:07:21Z")\
**Posts on this page:** 2\
**Page:** 2

<div class="post-metadata">

**Author:** ![ZurBob](https://avatars.discourse-cdn.com/v4/letter/z/71e660/32.png) [@ZurBob](https://boards.straightdope.com/u/ZurBob)\
**Post date:** [January 9, 2018, 1:24am UTC](https://boards.straightdope.com/t/plumbers-pipefitters-identifying-thread-size/805799/21 "2018-01-09T01:24:57Z")

</div>

> [@HoneyBadgerDC](#):
>
> A 5/16 tubing size compression fitting uses a thread size of 1/2" 24 threads per inch. You mostly see these used around light duty water applications like ice makers and coffee makers but air horns and a few other air fitting use them also. I am sure you have a 5/16 compression fitting.

I was in the process of replying that I too had considered this except for the fact that these fittings are cut with machine threads, not tapered pipe as the OP specified, when it occurred to me:

Tapered threads don’t have a major diameter. They can’t (they’re _tapered_).

As Lewis Black would say, “Something is ask-_eeew_ here!” and perhaps the OP’s specifications are a little… _off_?

---

<div class="post-metadata">

**Author:** ![HoneyBadgerDC](https://sea3.discourse-cdn.com/straightdope/user_avatar/boards.straightdope.com/honeybadgerdc/32/1033_2.png) [@HoneyBadgerDC](https://boards.straightdope.com/u/HoneyBadgerDC)\
**Post date:** [January 9, 2018, 1:37am UTC](https://boards.straightdope.com/t/plumbers-pipefitters-identifying-thread-size/805799/22 "2018-01-09T01:37:45Z")

</div>

> [@ZurBob](#):
>
> I was in the process of replying that I too had considered this except for the fact that these fittings are cut with machine threads, not tapered pipe as the OP specified, when it occurred to me:
> 
> Tapered threads don’t have a major diameter. They can’t (they’re _tapered_).
> 
> As Lewis Black would say, “Something is ask-_eeew_ here!” and perhaps the OP’s specifications are a little… _off_?

```
 I have seen castings that are slightly tapered. I think it makes it a bit easier to machine. I believe this is just an example of a tapered casting.

```

[Previous page](https://boards.straightdope.com/t/plumbers-pipefitters-identifying-thread-size/805799.md?page=1)
