# testing 123
**URL:** https://boards.straightdope.com/t/testing-123/62978
**Category:** About This Message Board
**Created:** [April 23, 2001, 7:48am UTC](https://boards.straightdope.com/t/testing-123/62978 "2001-04-23T07:48:27Z")
**Posts on this page:** 6
**Page:** 1
### Author:  [@MagicalSilverKey](https://boards.straightdope.com/u/MagicalSilverKey)
#### Post date: [April 23, 2001, 7:48am UTC](https://boards.straightdope.com/t/testing-123/62978/1 "2001-04-23T07:48:27Z")
[li]this is one[/li][li][_]this is two[/li][_][_][_]this is three
---
### Author:  [@MagicalSilverKey](https://boards.straightdope.com/u/MagicalSilverKey)
#### Post date: [April 23, 2001, 7:56am UTC](https://boards.straightdope.com/t/testing-123/62978/2 "2001-04-23T07:56:22Z")
[li]item a[/li]
> [@](#):
>
> sub item a
[li]item b[/li]
> [@](#):
>
> sub item b
---
### Author:  [@MagicalSilverKey](https://boards.straightdope.com/u/MagicalSilverKey)
#### Post date: [April 23, 2001, 7:57am UTC](https://boards.straightdope.com/t/testing-123/62978/3 "2001-04-23T07:57:50Z")
[li]Item a[/li]
```auto
sub item a
```
[li]Item b[/li]
```auto
sub item b
```
[li]Item C[/li]
```auto
sub item c
```
---
### Author:  [@evilbeth](https://boards.straightdope.com/u/evilbeth)
#### Post date: [April 23, 2001, 8:01am UTC](https://boards.straightdope.com/t/testing-123/62978/4 "2001-04-23T08:01:39Z")
That’s all!
---
### Author:  [@sleepyhead](https://boards.straightdope.com/u/sleepyhead)
#### Post date: [April 24, 2001, 3:03am UTC](https://boards.straightdope.com/t/testing-123/62978/5 "2001-04-24T03:03:28Z")
here goes a little test
> [@](#):
>
> ```
> Figure 5.17 shows a plot of axial DT vs. DOT for all the profiling experiments listed in Table 5.1. This plot was used as a "calibration curve" in order to extract information about the axial temperature gradients that occurred during polymer synthesis experiments (see section 5.2). Only DOT data were collected for most of the latter experiments. However, it was possible to crudely estimate the axial temperature gradients that developed during many of the synthesis experiments by using the calibration curve shown in Fig. ___. (The estimates are very approximate in most cases because the polymer synthesis heat treatment conditions often had some significant differences from the conditions used for the
>
> ```
or is it
[quote]
garble garble garble [\quote]
[italics] never [/italics] [bold] mind[/bold] that garbly gok.
---
### Author:  [@sleepyhead](https://boards.straightdope.com/u/sleepyhead)
#### Post date: [April 24, 2001, 3:26am UTC](https://boards.straightdope.com/t/testing-123/62978/6 "2001-04-24T03:26:12Z")
ahh… its just \*\* bold\*\* and underline and _italics_ okay