I have a GE GXWH20S Whole House Water Filter housing with a sediment filter. The in/out pipes are 1/2" PVC. I would like to replace this unit with a Big Blue filter housing and a carbon filter. The in/out pipes must be 3/4 inch to fit the new unit. Can you provide any tips on how to install this new filter housing without risking the loss of any water pressure? Thank you.
Welcome, Danny_G_1. I’m moving this thread to The Barn House from About This Message Board.
You’ll need a samoflange.
**MODERATOR NOTE:**This is not funny.
If you can’t give a real answer, then don’t say anything at all, don’t try to be all jokey.
Don’t do this again.
Then you should probably post a notice that jokes aren’t allowed in ATMB anymore.