testing 123

[MagicalSilverKey]

[li]this is one[/li][li][]this is two[/li][][][]this is three

[MagicalSilverKey]

[li]item a[/li]

sub item a

[li]item b[/li]

sub item b

[MagicalSilverKey]

[li]Item a[/li]

sub item a

[li]Item b[/li]

sub item b

[li]Item C[/li]

sub item c

[evilbeth]

That’s all!

[sleepyhead]

here goes a little test

Figure 5.17 shows a plot of axial DT vs. DOT for all the profiling experiments listed in Table 5.1. This plot was used as a "calibration curve" in order to extract information about the axial temperature gradients that occurred during polymer synthesis experiments (see section 5.2). Only DOT data were collected for most of the latter experiments. However, it was possible to crudely estimate the axial temperature gradients that developed during many of the synthesis experiments by using the calibration curve shown in Fig. ___. (The estimates are very approximate in most cases because the polymer synthesis heat treatment conditions often had some significant differences from the conditions used for the 

or is it

[quote]
garble garble garble [\quote]

[italics] never [/italics] [bold] mind[/bold] that garbly gok.

[sleepyhead]

ahh… its just ** bold** and underline and italics okay