I found one new available on-line. Been playing with it but have found a couple pieces that I think may have been mis-cut but have nothing to compare them to. Was wondering if anyone could look at theirs to see if my suspicions are correct.
Slider rod #16 has 3 notches cut into it. Should they all be the same size? The notch on the bottom is standard rod width but of the two on the side one of them is cut too narrow. About 3/4 of what it should be.
Same with rod #17. Three notches are all standard rod width but the 4th notch on the left side if only 3/4 of a rod wide.
Are they supposed to be that narrow or do I need to alter mine?