Maybe this should go in GQ, but it’s mostly a personal request to tap the SDMB Mass Mind.
I’m looking for a tool to cut or punch small (15-30mm) circles/squares/hexes from chipboard. So far, most of what I’ve found is either light-duty punches that will handle paper, but nothing heavier.
These are the tools I use at work, they may be more than you are willing to spend.
I die-cut rubber parts for automotive, we adapt these punches from the cardboard cutting industry.
The punches usually run $4-$5 for a straight wall punch if you order ten at a time. They may sell for less.
Thanks – the cost isn’t prohibitive (but I’ll want to do a little research first), though the shipping might be pretty steep for such a weighty device.
I just talked to one of the maintenance guys and they have used a toggle clamp mounted vertically with the punch fixtured to the bottom.
Lot cheaper. It should do the trick too.